Seat cushion installation instructions

Here you can find out how to fit our seat cushions to your motorbike seat.

(1) Alignment

Place the cushion in the desired location. Ensure that the cushion is centred. You can also mould the cushion into shape – when it is fresh out of the packaging, it is still relatively neutral, but over time the cushion will adapt to your preferred shape.

(2) Velcro strips

Turn your bench seat with the cushion over, then place the Velcro strips over the sides towards the centre of the seat. Pull the plastic sleeve on one side of the Velcro strips towards the centre and secure the Velcro strips.

3) TIGHTEN

Now you can thread the opposite Velcro strip into the respective plastic sleeve and tighten it by pulling on the Velcro strip.

4) OVERHANG

Adjust the Velcro straps as needed to align the plastic buckle in the centre of the seat. If the Velcro straps get in the way of your desired position for the seat mount, you can also leave the Velcro straps longer and move them forwards or backwards as needed. IMPORTANT: The Velcro surface should protrude by at least 6 cm.

5) FINAL ASSEMBLY

Once you are satisfied with the position of the cushion and the placement of the adhesive tape, you are ready for your next ride. We wish you a safe and enjoyable journey at all times.

SAFETY INSTRUCTIONS

For use only on the existing seat, not as a stand-alone seat.

Ensure that the cushion is securely fastened before driving. Check the durability of the Velcro fasteners regularly.

Do not leave the cushion permanently mounted outdoors without a cover.